Friday, October 7, 2022
HomeElectronicsDrill depth show with gyro sensor - Open Electronics

Drill depth show with gyro sensor – Open Electronics


By on September 22, 2022

Most bench drills have a ruler to learn the drilling depth. The higher the accuracy at which the specified place will be learn, the higher the success of the job. On this challenge we see an alternate proposal: a show during which we see the drilling depth due to a gyroscopic sensor and an 8-digit 7-segment show with Arduino Nano help.

 

However how is the depth of drilling measured? There are a number of potentialities for a size measurement. An ultrasonic measurement may work, a wire encoder and a rotary encoder are additionally alternatives, right here we see an alternate answer.

Most drills have a facet handwheel to regulate the depth which will be turned approx. 270 °. So not even a full flip, you’ll be able to then measure the angle with a gyro sensor. The cable connection can’t be twisted and just one cheap part is required (such because the MPU-6050).

Extra information

About Bianchi Gabriele



RELATED ARTICLES

LEAVE A REPLY

Please enter your comment!
Please enter your name here

Most Popular

Recent Comments